Adding Devices/Device Classes
TOC
Adding Device Classes
Unify the classification of devices of the same type or hard disks with the same business logic in cluster nodes, customize device classes according to storage needs, and allocate different storage contents to different types of storage disks.
Notes
Adding device classes is not supported when the cluster type is Extend.
Procedure
-
Enter Administrator.
-
In the left navigation bar, click Storage Management > Distributed Storage.
-
Click the Device Classes tab.
-
Click Add Device Class and configure the relevant parameters according to the following instructions.
Parameter Description Name The name of the device class. The following names cannot be used for the device class: hdd,ssd,nvme.Storage Devices To add storage devices to a device class, you can choose between the Selection DeviceandInput Devicemethods:- Selection Device:
Select from available storage devices. A device is considered available if it meets the following criteria:- Device type is either disk or mpath
- No file system is detected (fsType is blank)
- Capacity exceeds 10 GiB
Note: Requires prior deployment of the Alauda Build of LocalStorage Operator.
- Input Device:
Manually input the names of the blank devices under the node, such assda.
Note: For optimal performance and management, it is strongly advised to utilize raw disk as storage devices instead of employing individual partitions on a disk.
- Selection Device:
Adding Devices
Map available hard disks to storage devices for usage and management.
Note: Once hard disks are added as storage devices, updating or removing them through the interface is not supported.
Procedure
-
Enter Administrator.
-
In the left navigation bar, click Storage Management > Distributed Storage.
-
Click the Device Classes tab.
-
On the right side of the device class, click Add Device, and configure the relevant parameters according to the following instructions.
Parameter Description Specified Disks To add storage devices to a device class, you can choose between the Selection DeviceandInput Devicemethods:- Selection Device:
Select from available storage devices. A device is considered available if it meets the following criteria:- Device type is either disk or mpath
- No file system is detected (fsType is blank)
- Capacity exceeds 10 GiB
Note: Requires prior deployment of the Alauda Build of LocalStorage Operator.
- Input Device:
Manually input the names of the blank devices under the node, such assda.
Note: For optimal performance and management, it is strongly advised to utilize raw disks as storage devices instead of employing individual partitions on a disk.
- Selection Device:
-
Click Add.
Hard Disk Status
-
Normal: The corresponding status of the storage device is IN+UP.
-
Abnormal: The corresponding status of the storage device is IN+DOWN.
-
Offline: The corresponding status of the storage device is OUT+UP.
-
Fault: The corresponding status of the storage device is OUT+DOWN.